Power polarity question

Hello,

   I am working on a project where I'm using some DIY wires to make a magnetic  electrical connection (I've done that part before and it works, not worried about that). I'm going to have a couple of these connections in series (A to B, B to C, etc.), however I want the ability to be able to rotate the modules depending on the need at a show. This leads me to the below scenarios: (plus and minus are the magnet polarity, red and black are the wires)

Normal:

Red+     -Red        module front     Red+     -Red

Black-  +Black                                       Black-   +Black

 

Reversed:

Red+     -Black                                      Black+  -Red

Black-  +Red        module front       Red-     +Black

 

Is it okay to have reverse electrical polarity running through the Brickstuff products? I'm only planning on using lights and branch boards, no controllers or effects.

 

   Thanks,

        Bryan

7replies Oldest first
  • Oldest first
  • Newest first
  • Active threads
  • Popular
  • Hi Bryan, thanks for your message.  It's ok to reverse polarity as long as you just have LEDs, however the LEDs themselves won't light with reverse polarity as they are diodes that only pass electricity in one direction.

    Have you thought about using magnetic connectors with one conductor in the center, so you always have correct polarity no matter the orientation?  See the photo below for what we used several years ago in our experimental power connectors.  We don't sell these mounted inside LEGO couplers anymore, but we could sell you just the male + female magnetic connector pairs and you could solder your wires to the backside.

    Like
  • Hi Rob,

        Depending on the price that might be do-able. However from the picture it still looks like the magnet can't change orientation due to the wire coming out of the back. I would still be limited in which direction the modules could face, unless the magnet set up works differently than shown below.

    A+ -B     B+  -C    normal

    A+ +B     B-   -C    module flipped

    What I'm thinking of might not work without some rebuilding/rerouting of wires each time I want to flip the modules.

       Bryan

    Like
  • Bryan Fraser Hi Bryan, I could sell you a pair of couplings for $5.95.  We have a lot of them, so let me know if that would work and how many you'd like.  I could take some better photos of just the connectors so you could see the solder tabs on the back if you'd like.

     

    The good thing about the magnet setup is that the two connectors are contained within the circle.  One conductor is in the center (the gold pin in the photo above), and the other conductor is the outer silver ring.  So it doesn't matter what orientation the connections happen-- all that matters is that one male connector pairs with a female, and they have pretty good clutch so they will attract each other and pretty much connect automatically.

    Like
  • Rob Klingberg Hi Rob, If you have 8 pairs of connectors I could buy, I would be willing to play with them.

      Bryan

    Like
  • Bryan Fraser LOL yeah, we've got hundreds.  Let me put them up on the website in the DIY section-- then you can order as many as you'd like.  I'll try to get them up today.

    Like
  • Rob Klingberg Thank you

    Like
Like Follow
  • 5 yrs agoLast active
  • 7Replies
  • 59Views
  • 2 Following