Need Help with Sound & Remote
I'm getting a lot of feedback from the Intelligent Sound Module and I'm having trouble assigning sounds to the ports. Can someone help?
My setup:
Coin Cell Battery Pack with On-Off Switch connected to a 3-Port Expansion Board
That board is connected to the TRUNK11 and another 3-Port Expansion Board.
The second expansion board is connected to the sound module and controller board.
I did not delete the stock files from the soundboard, and I added three short MP3s.
Output1 is connected to 4 LEDS that flash in sequence: 1, 2, 3, 4, 3, 2 indefinitely.
I'm getting a ton of feedback from the speaker as I go through the programming steps, and it's not playing any sounds.
-
I think I figured it out...not enough juice. Was hoping to fit all of this in a Pinewood Derby Car but that's not looking likely.
-
Brad Yes, that's definitely the reason! Using coin cells with pretty much anything sound-related will cause "lack of juice" issues. :-(
-
Rob Klingberg Yep, I wish I had noticed the LiPo adapter earlier. This is gonna be awesome.