Main Brickstuff Website

How to enable Javascript

Latest Posts

Re: Disney Lego Castle @Scott Hartlett Hi Scott, sure, please see the attached PDF document. This shows all the lighting connections in the castle kit-- since you don't have the kit yet,…
Attachment
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- Set-Specific Kits
- Reported - view
Re: Disney Lego Castle Thanks @Scott Hartlett for the question. You would be able to add as many additional lights as you wanted by piggybacking off the OUT1 plug on the TRUNK08 master controller.…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- Set-Specific Kits
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Freakmaster Remember, the entire bottom of the vehicle (including all recessed areas) is where we place all the electronics in our kit. You could try re-locating these inside the car (the wires…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Jaidev Patel Likely not. We have all of our control board, circuitry, sound modules, etc. occupying the entire bottom of the car. You could try putting everything inside the car instead of…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Millennium Falcon Engine Sound Issue Hi, this is caused by an insufficient supply of power. Telltale sign is that everything works well until the engine lights come on, at which point the total power consumption rises exponentially,…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- Product Support and Issues
- Reported - view
Re: PicoLED power draw @Scott Beasley Wonderful, can't wait to see it!
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- Brickstuff Lights
- Reported - view
Re: PicoLED power draw @Scott Beasley Hi Scott, each Pico should pull 10-15mA.
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- Brickstuff Lights
- Reported - view
Re: Full Arduino Shield! Hello Arduino enthusiasts! I'm happy to announce that today we have released three new products that work with the Arduino Shield: The Brickstuff Intelligent Sound Module 4-Channel RF Remote and…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- Arduino
- Reported - view
Re: NASA Saturn V # 21309 @Erick Marino Thanks for your comment, perhaps @Christian Nanini can comment with a list of parts (LEGO and non-LEGO) that he used to mount the rocket.
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Rick rivera Glad you like it. I liked that it ended up being swappable with the 2x2 round brick that comes with the LEGO set, so you can decide whether to use the big piece or the small one,…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Rick rivera Thanks, yeah I had fun searching for quotes! 😉
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Freakmaster Absolutely.
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Nate Sounds good, I get the feeling we're gonna be making these kits for a while. 😂
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 2
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Graham Starke Thanks so much!
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Kenneth Higgins Thank you!
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Larry Andersen Thank you so much!
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) OK ECTO-1 FANS, you've been patient. You've been MORE than patient, actually. And you know we've been working hard to make a kit that it better than any of the others.…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 2
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Kenneth Higgins I have. It's pretty obvious they've been reading this forum and taking people's suggestions for their kit. Thankfully we kept a few surprises up our sleeves.…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 2
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Light and Sound Kit for the 2020 Creator Expert Ecto-1 (#10274) @Kenneth Higgins This isn't a race. What we are making will be nothing like LMB's kit. My goal is to get a video posted by Monday.
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 3
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Connector Specifications/Types Hi, what's your project? Maybe we can help. Our standard connectors are JST 1.0mm SH connectors, and our smaller connectors are 0.8mm JST SUR connectors.
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- General Questions & Answers
- Reported - view
Re: 2017 Star Wars Snowspeeder #75144 @Michael Mejia We've finally been able to develop round engine lights specially designed for the snowspeeder: These work really well and my task now is to finish development on a new sound/lighting…
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Lighting the Palace Cinema Marquee @Adeline We'll be updating the homepage of our website with the news, and also likely posting to Facebook and Twitter. Gotta spread the news! 😄
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- Customer Tips and Tricks
- Reported - view
Re: Lights for the 76023 Tumbler @William C Cheezum Jr We have a total of 15 lights. I could include 2 of our 10-port adapters, that way you'd have room to expand later. Sound good?
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- What Lights Do I Use For [a specific] LEGO Set?
- Reported - view
Re: Lighting the Palace Cinema Marquee @Adeline Hi, nope, you definitely didn't miss out-- we have these ready and just need to get 'em packaged!
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- 1
- Customer Tips and Tricks
- Reported - view
Re: littleBits + Power Functions motors @EJ Mak Sounds good, I'm sure you're aware that Amazon has a number of ready-made H-Bridge modules available.
- Rob Klingbergmoderator
- Chief Enthusiast
- Rob_Klingberg
- 4 yrs ago
- General Questions & Answers
- Reported - view

1 19 20 21 22 23 70 Next

Back to top

moderator

Rob Klingberg

Rob_Klingberg

Chief Enthusiast

Rosemount, Minnesota, USA

1763
540
8

Joined: Sun Aug 14 01:27:56 UTC 2016

Follow

www.brickstuff.com

Tinkerer turned tech sales guy turned Chief Enthusiast. Started Brickstuff in 2011. Always amazed by the creativity of our customer community around the world!